ISO INTERNATIONAL STANDARD 10806 Second edition 2003-11-15 Pipework Fittings for corrugated metal hoses Tuyauteries Raccords pour tuyaux métalliques flexibles onduleux Reference number ISO 10806:2003(E) ISO @ ISO 2003 by IHS under lic Not for Resale ISO10806:2003(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below ?ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ationalgazaiSandardizato @Iso2003-All rightsreserved ermittedwithoutlicense from IHS Not for Resale ISO 10806:2003(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISO established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. iso collaborates closely ywith the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote ISO 10806 was prepared by Technical Committee ISO/TC 5, Ferrous metal pipes and metallic fittings. Subcommittee sc 11, Metal hoses and expansion joints. revised. ii ISO 10806:2003(E) Introduction taken to add additional information not available for the first edition of iSO 10806. The major changes are: addition of a clause on design; revision of the type descriptions and the symbols; addition of conical nipples and adaptors; addition of three series of fixed flanges; deletion of the PN 16 loose plate flange series. @IsO2003-All rightsreserved y IHS unde Not for Resale INTERNATIONAL STANDARD ISO10806:2003(E) Pipework Fittings for corrugated metal hoses Scope This International Standard specifies the characteristics of fittings for corrugated metal hose conforming with therequirementsofis010380. This International Standard is also valid for other fittings provided they meet the material, design, assembly and test requirements specified herein. 2Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies Iso 7-1, Pipe threads where pressure-tight joints are made on the threads - Part 1: Dimensions, tolerances and designation IsO 228-1, Pipe threads where pressure-tight joints are not made on the threads - Part 1 : Dimensions, tolerances and designation Iso 724, /sO general-purpose metric screw threads - Basic dimensions Is