ISO INTERNATIONAL STANDARD 10601 Second edition 2007-03-01 Micaceous iron oxide pigments for paints Specifications and test methods Pigments d'oxyde de fer micacé pour peintures - Spécifications et méthodes d'essai Reference number ISO 10601:2007(E) @ ISO 2007 by IHS under lic itted without license from IHS Not for Resale ISO 10601:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shail not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF fle can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2007 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2007 - All rights reserved ermittedwithoutlicense from IHS Not for Resale ISO 10601:2007(E) Contents Page Foreword iv Introduction 1 Scope 2 Normative references. 3 Terms and definitions.. 4 Classification.... 2 5 Required characteristics and their tolerances 6 Sampling...... 7 Assessment of thin-flake content ... 8 Test report. Copyrght International Organization forstandardizalon ghts reserved ii d by IHS under ise with IS ut license from IHS Not for Resale ISO 10601:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10601 was prepared by Technical Committee ISO/TC 35, Paints and varnishes, Subcommittee SC 2, Pigments and extenders. This second edition cancels and replaces the first edition (IsO 10601:1993), which has been technically revised. The main technical changes are: a) the description of the grades has been changed and the grade “non-lamellar" deleted; b)the requirements for the residue on sieve have been changed. @ ISO 2007 - All rights reserved nal Organization for Standardizatior ISO 10601:2007(E) Introduction Micaceous iron oxide pigments were previously included in IsO 1248 (classified in the colour group “grey with metallic sheen") but are explicity excluded from the revised edition published in 2006. In this revised edition of an essentially lamellar particle shape. whether they are produced synthetically or, if a refined natural oxide, on the location where the ore was mined. Theprimaryuseofmicaceo