ISO INTERNATIONAL STANDARD 10594 Second edition 2006-09-15 Micrographics Rotary camera systems Test target for checking performance Micrographie- Systemes de caméras cinétiques - Cible de controle pourverifierlaperformance Reference number ISO 10594:2006(E) @ ISO 2006 py IHS under lic ted without license from IHS Not for Resale ISO10594:2006(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF fle can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. ?ISO2006 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2006 - All rights reserved edwithoutlicense from IHS Not for Resale ISO 10594:2006(E) Contents Page Foreword. Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Description of the test target. 4.1 Characteristics of the base.. 4.2 Test target layout. 4.3 4.4 Identification 5 Microfilming of the test target . 5.1 Exposure setting.... 5.2 5.3 Number of exposures 6 Test target evaluation procedure ... 6.1 Microscope... 6.2 Mechanical performance.. 6.3 Optical quality (resolving power) 6.4 Reduction ratio. 6.5 Legibility test 7 Results of the tests. Annex A (informative) Characteristics of rotary camera. Bibliography 10 Copyright International Organization for Stadardizalon ghts reserved ii ut license from IHS Not for Resale ISO 10594:2006(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the InternationalElectrotechnicalCommission(lEC)onallmattersofelectrotechnicalstandardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10594 was prepared by Technical Committee ISO/TC 171, Document management applications, Subcommittee SC 1, Quality. This second edition cancels and replaces the first edition (IsO 10594:1997), which has been technically revised. @ ISO 2006 - All rights reserved ional Organization for Standardizatior ISO 10594:2006(E) Introduction This International Standard has been prepared to provide a means of checking the quality of output of rotary that specified for checking planetary cameras in ISO 10550. the original document. In order to keep such deterioration within acceptable limits, the output of the camera needs