ISO INTERNATIONAL STANDARD 10567 Second edition 2007-10-01 Earth-moving machinery Hydraulic excavators Lift capacity Engins de terrassement- Pelles hydrauliques - Capacite de levage Reference number ISO 10567:2007(E) ISO @ ISO 2007 py IHS under lic Not for Resale ISO 10567:2007(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. . In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure thatthe file is suitable foruse by IsO member bodies. In the COPYRIGHT PROTECTED DOCUMENT @ISO2007 electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or ISO's member body in the country of the requester. ISO copyright office Casepostale56·CH-1211Geneva20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2007 - All rights reserved T by IHS unde working permitted without license from IHS Not for Resale ISO 10567:2007(E) Contents Page 1 Scope 2 Normative references 3 Terms and definitions . 1 4 Calculations 4 5 Verification testing ... 8 6 Validation of calculated values ..... 13 Rated lift capacity chart 13 Annex A (informative) Examples of typical rated lift capacity charts 14 Bibliography . 16 CopyrightInternatinalOrganizatiosadardization'ghtsreserved ili vided by IHS under lic se with I: ted without license from IHS Not for Resale ISO 10567:2007(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2 adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10567 was prepared by Technical Committee ISO/TC 127, Earth-moving machinery, Subcommittee SC 1, Test methods relating to machine performance. This second edition cancels and replaces the first edition (isO 10567:1992), which has been technically revised. @ISO2007-All rights reserved Not for Resale ISO 10567:2007(E) INTERNATIONAL STANDARD Earth-moving machinery Hydraulic excavators Lift capacity 1 Scope This International Standard provides a uniform method for calculating the lift capacity of hydraulic excavators and specifies a procedure for verifying the calculations. It is applicable to the limits of both hydraulic lift capacity 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IsO 7135, Earth-moving machinery—Hydraulic excavatorsTerminology and commercial specifications Iso 9248, Earth-moving machinery— Units for dimensi