ISO INTERNATIONAL STANDARD 105-P02 Third edition 2002-09-15 Textiles Tests for colour fastness Part P02: Colour fastness to pleating: Steam pleating Textiles— Essais de solidité des teintures- Partie Po2: Solidite des teintures au plissage: Plissage a la vapeur Reference number ISO 105-P02:2002(E) ISO @ ISO 2002 Copyright International Organization for Standardization ted without license from IHS Not for Resale ISO 105-P02:2002(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by isO member bodies. In the unlikely event @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland CopyightinteratinalOorganization for Standardization @ISO2002-All rights reserved Not for Resale ISO 105-P02:2002(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO committees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeenestablishedhas the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this part of isO 105 may be the subject of patent rights. Iso shall not be held responsible for identifying any or all such patent rights. ISO 105-P02 was prepared by Technical Committee ISO/TC 38, Textiles, Subcommittee SC 1, Tests for coloured textilesand colorants. This third edition cancels and replaces the second edition (IsO 105-P02:1993), of which it constitutes a minor revision. Iso 105 was previously published in thirteen “parts", each designated by a letter (e.g.“Part A"), with publication datesbetween1978and1985.Eachpartcontainedaseriesof"sections”,eachdesignatedbytherespectivepart letter and by a two-digit serial number (e.g.“Section Ao1"). These sections are now being republished as separate these parts is given in ISO 105-A01. ili maaaiandardizato orneworkingmitedwithout licene fromH Not for Resale INTERNATIONALSTANDARD ISO 105-P02:2002(E Textiles Tests for colour fastness Part P02: Colour fastness to pleating: Steam pleating 1 Scope 1.1 and in all forms to the action of steam-pleating processes. The materials are not pleated during the test, and it is emphasized that the test is not intended for assessing the quality of the pleating process. 1.2 Three tests differing in severity are provided; one or more of them may be used depending on the requirements. 2Normative references t