ISO INTERNATIONAL STANDARD 10333-1 Firstedition 2000-07-01 AMENDMENT 1 2002-03-15 Personal fall-arrest svstems Part 1: Full-body harnesses AMENDMENT 1 Systemes individuels d'arret de chute -- Partie 1: Harnais complet AMENDEMENT1 Reference number ISO10333-1:2000/Amd.1:2002(E) ISO @ISO 2002 No reproduction or networking permited withoutlicense from IHS Not for Resale ISO 10333-1:2000/Amd.1:2002(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unlessthe typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2002 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either Iso at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii ISo2002-Allrightsreserved Copyright Intemational Organization for Standardization Not for Resale IS0 10333-1:2000/Amd.1:2002(E) Foreword ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the IsO/lEc Directives, Part 3. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an Internationa Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this Amendment may be the subject of patent rights. Iso shall not be held responsible for identifying any or all such patent rights. Amendment 1 to international Standard ISO 10333-1:2000 was prepared by Technical Committee ISO/TC 94, Personal safety Protective clothing and equipment, Subcommittee sc 4, Personal equipment for protection againstfalls. @ISO2002-All-riahtsreserved Not for Resale ISO 10333-1:2000/Amd.1:2002(E) Personal fall-arrest systems -- Part 1: Full-body harnesses AMENDMENT 1 Page 5, subclause 4.2.1 b) 3) Delete "Class L for fall-arrest purposes whilst ladder climbing" and renumber the subsequent item 4) to item 3) Page 5, subclause 4.2.2 Delete the text and replace it with the following text: "Class A FBH are designed to support the body during and after the arrest of a fall. They shall have at least one fall-arrest attachment element incorporated. A fall-arrest attachment element shall be positioned so that it lies either at the back of the wearer and centrally between the upper shoulder blades, or centrally at the front of the chest at approxim