ISO INTERNATIONAL STANDARD 10110-17 First edition 2004-03-01 Optics and photonics Preparation of drawings for optical elements and systems Part 17: Laser irradiation damage threshold Optique et photonique - Préparation des dessins pour éléments et systemesoptiques Partie 17: Seuil de dommage au rayonnement laser Reference number ISO 10110-17:2004(E) ISO @ ISO 2004 Copyright International Organization for Standardization ted without license from IHS Not for Resale ISO 10110-17:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademarkof AdobeSystems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2004-All rights reserved nitted without licensefrom IHS Not for Resale ISO 10110-17:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attentionisdrawntothepossibilitythatsomeoftheelementsofthisdocumentmaybethesubjectofpatent rights. Iso shall not be held responsible for identifying any or all such patent rights. ISO 10110-17 was prepared by Technical Committee ISO/TC 172, Optics and photonics, Subcommittee SC 1, Fundamental standards. IsO 10110 consists of the following parts, under the general title Optics and photonics - Preparation of drawings for optical elements and systems: Part 1: General Part 2: Material imperfections Stress birefringence Part 3: Material imperfections — Bubbles and inclusions Part 4: Material imperfections Inhomogeneity and striae Part 5: Surface form tolerances Part 6: Centring tolerances Part 7: Surface imperfection tolerances Part 8: Surface texture Part 9: Surface treatment and coating Part 10: Table representing data of optical elements and cemented assemblies Part 11: Non-toleranced data Part 12: Aspheric surfaces Part 14: Wavefront deformation tolerance Part 17: Laser irradiation damage threshold ii maaaiandardizato orneworkingmitedwithout licene fromH Not for Resale INTERNATIONAL STANDARD ISO 10110-17:2004(E) Optics and photonics Preparation of drawings for optical elements and systems : Part 17: Laser irradiation damage threshold 1 Scope Iso 10110 specifies the presentation of design and functional requirements for optical elements in technical drawingsusedformanufacturingandinspection. This part of isO 10110 specifies rules for the indication of the damage threshold from laser irradiation up to which