ISO INTERNATIONAL STANDARD 10075-3 First edition 2004-08-15 Ergonomic principles related to mental workload - Part 3: Principles and requirements concerning methods for measuring and assessing mental workload Principes ergonomiques relatifs a la charge de travail mental - Partie 3: Principes et exigences concernant les methodes de mesurage et d'evaluation de la charge de travail mental Reference number ISO 10075-3:2004(E) @ ISO 2004 Copyright International Organization for Standardization ted without license from IHS Not for Resale ISO 10075-3:2004(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below @ISO2004 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland yemainagazainandardizato @ISO2004-All rights reserved nitted without licensefrom IHS Not for Resale ISO 10075-3:2004(E) Contents Page Foreword .iv Introduction 1 Scope 2 Normative references . 3 Terms and definitions 4 Measurement and assessment of mental workload. 4.1 General principles ... 4.2 Procedural requirements.. 4.3 Quantitative requirements for measuring instruments..... 4.4 Documentation requirements .... 10 Annex A (informative) Additional information concerning generalizability .13 Annex B (informative) Checklist for choosing an instrument.. Bibliography .15 Copyright International Organizaion for standardizalon'ghts reserved ili Not for Resale ISO 10075-3:2004(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10075-3 was prepared by Technical Committee ISO/TC 159, Ergonomics, Subcommittee SC 1, Ergonomicguidingprinciples. Is 10075 consists of the following parts, under the general title Ergonomic principles related to mental workload: Part 1: General terms and definitions Part 2: Design principles Part 3: Principles and requirements concerning methods for measuring and assessing mental workload A Technical Report will accompany these parts to explain to non-experts the ba