ISO INTERNATIONAL STANDARD 10059-2 First edition 2003-12-15 Dense, shaped refractory products - Determination of cold compressive strength Part 2: Test with packing Produits réfractaires faconnés denses Détermination de la resistance a la compression a température ambiante- Partie 2: Essai avec intercalaires Reference number X ISO 10059-2:2003(E) ISO @ ISO 2003 ISO10059-2:2003(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the respons bility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. @ISO2003 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO'smemberbody in thecountry of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii @IsO2003-Allrightsreserved ISO 10059-2:2003(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEc Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 10059-2 was prepared by Technical Committee ISO/TC 33, Refractories Iso 10059 consists of the following parts, under the general title Dense, shaped refractory products - Determination of cold compressive strength: - Part 1: Referee test without packing Part 2:Test with packing IsO2003—All rightsreserved ili INTERNATIONAL STANDARD ISO 10059-2:2003(E) Dense, shaped refractory products - Determination of cold compressive strength : Part 2: Test with packing Scope This part of isO 10059 specifies a method for the determination of the cold compressive strength of dense shaped refractory products as an alternative to that described in IsO 10059-1. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated document (including any amendments) applies. IsO 3599, Vernier callipers reading to 0,1 and 0,05 mm IsO 5o17, Dense shaped refractory products- Determination of bulk density, apparent porosity and true porosity 3Terms and definitions For the purposes of this document the following terms and definitions apply. 3.1 cold compressive strength load is applied, that a refractory will withstand before failure occurs 3.2 dense, shaped refractory product refractory with specific dimensions, having a true porosity of less than 45 % when measured in accordance withISO5017 4 Principle A test piece of known dim