ISO INTERNATIONAL STANDARD 10474 Secondedition 2013-07-01 Steel and steel products Inspection documents Aciers et produits sidérurgiques - Documents de controle Reference number IS010474:2013(E) ISO @ IS0 2013 IS0 10474:2013(E) COPYRIGHTPROTECTED DOCUMENT @IS02013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either Iso at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland ii IS02013-Allrightsreserved IS0 10474:2013(E) Contents Page Foreword .iv 1 Scope. 1 2 Normative references 1 3 Terms and definitions .1 4 Inspection documents based on non-specific inspection .2 4.1 Declaration of compliance with the order “2.1" 2 4.2 Test report"2.2" 2 5 Inspection documents based on specific inspection .2 5.1 Inspection certificate 3.1 2 5.2 Inspection certificate 3.2 2 6 Inspection documents supplied by an intermediary 3 7 Validation of inspection documents .3 8 Summary of documents. .3 Bibliography .4 @ IS0 2013 - All rights reserved iii IS0 10474:2013(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out throughIsotechnicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committee has been established has the right to be represented on that committee. International ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. The procedures used to develop this document and those intended for its further maintenance are described in the IsO/IEC Directives, Part 1. In particular the different approval criteria needed for the different types of IsO documents should be noted. This document was drafted in accordance with the editorial rules of the ISo/IEC Directives, Part 2. www.iso.org/directives Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. Details of any patent rights identified during the development of the document will be in the Introduction and/or on the Iso list of patent declarations received. www.iso.org/patents Any trade name used in this document is information given for the convenience of users and does not constituteanendorsement. The committee responsible for this document is ISO/TC 17, Steel, Subcommittee SC 20, General technical delivery conditions, sampling and mechanical testing methods. This second edition cancels and replaces the first edition (IS0 10474:1991), which has been technicallyrevised. iv @ IS0 2013 - All rights reserved IS0 10474:2013(E) INTERNATIONAL STANDARD Steel and steel products Inspection documents Scope This International Standard defines the different types of inspection documents supplied to the purchaser, in accordance with the requirements of the order, for the delivery of steel products. This International Standard is to be used in conjunction with other International Standards which specify the general technical delivery conditions: for steel and steel products, see IS0 404; for steel castings, see Is0 4990. NOTE This International Standard can also apply to other products. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. IS0 404:2013, Ste