ISO INTERNATIONAL STANDARD 13041-6 Second edition 2009-06-15 Test conditions for numerically controlled turning machines and turning centres Part 6: Accuracy of a finished test piece Conditions d'essai des tours a commande numérique et des centres de tournage- Partie 6: Exactitude d'une piece d'essai usinee Reference number ISO 13041-6:2009(E) @ ISO 2009 HS under ted without license from IHS Not for Resale ISO 13041-6:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT @ ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2009 - All rights reserved py IHS unde I without license from IHS Not for Resale ISO 13041-6:2009(E) Contents Page Foreword. Introduction 1 Scope 2 Normative references 3 Preliminary remarks . 3.1 Measuring units. 3.2 Reference to ISO 230.. 3.3 3.4 Tests to be performed. 3.5 Measuring instruments .. 3.6 Fixing of test pieces . 3.7 Materials of test pieces, tooling and cutting parameters .. 3.8 Sizes of test pieces.... 3.9 Information to be recorded 3.10 Machine size categories.... 4 Machining tests. Bibliography.. 12 Copyright International Organization for Standardizalon ghts reserved ii d by IHS under Not for Resale