INTERNATIONALSTANDARDISO10155:1995 TECHNICAL CORRIGENDUM 1 Published 2002-02-15 Stationary source emissions -- Automated monitoring of mass concentrations of particles Performance characteristics, test methods and specifications TECHNICAL CORRIGENDUM 1 Emissions de sources fixes - Controle automatique des concentrations en masse de particules -- Caracteristiques de fonctionnement, modes operatoires d'essai et spécifications RECTIFICATIFTECHNIQUE1 Technical Corrigendum 1 to International Standard IsO 10155:1995 was prepared by Technical Committee IsO/TC 146, Air quality, Subcommittee Sc 1, Stationary source emissions. Page 9 In annex A, clause A.3 Determination of the confidence interval for the linear regression Delete equation (A.11) and replace with: S SxxSyy ICS 13.040.40 Ref.No.ISO 10155:1995/Cor.1:2002(E) @IsO 2002 - All rights reserved Printed in Switzertand No reproduction or networking permitted without license from IHS Not for Resale 4851903 0606558 612 INTERNATIONAL ISO STANDARD 10155 First edition 1995-04-01 Stationary source emissions - Automated monitoring of mass concentrations of particles - Performance characteristics, test methods and specifications Emissions de sources fixes -- Controle automatique des concentrations en massedeparticules- Caracteritisques defonctionnement, modes opératoires d'essai et spécifications ISO Reference number ISO 10155:1995(E) Provided by IHS under licen se with ISC Noreproduction or networking permitted without license from IHS Not for Resale 4851903 0606559 559 ISO10155:1995(E) Contents Page Scope 2 Normative references 3 Definitions 2 4 Measurement system components 3 4.1 Sampling and analytical components 3 4.2 Data recorder 3 5 Installation criteria 3 5.1 Sampling location 3 5.2 Environmental conditions System performance specifications 4 6.1 Response time 4 6.2 Zero drift 4 6.3 Span 5 6.4 Span drift 5 6.5 Calibration specifications 5 7 Test procedures to validate specifications 5 7.1 Response time test 5 7.2 Zero and span setting in the field 6 7.3 System calibration 6 Annexes A Statistical treatment of data 8 B Possible sampling configurations 13 c Test data forms 14 D Example of calculations 16 ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm,without permission in writing from the publisher. InternationaiOrganizationforStandardization Case Postale 56: CH-1211Geneve 20: Switzerland Printed in Switzerland ational Organization for Standardizat Provided by IHS under license with IS Not for Res